Help What's The Best Method To Secure Wiring On Your Heli ?

Discussion in 'The Chat Room' started by HeliGods, Apr 25, 2014.

By HeliGods on Apr 25, 2014 at 6:39 PM
  1. HeliGods

    HeliGods Mark - Administrator Staff Member

    I use a bit of velco strap around the wires and then a zip tie pulled down over that, Velco strap stop the zip tie cutting into the wires.

    What do you do ?
     
    HeliGods, Apr 25, 2014
    #1

Comments

Discussion in 'The Chat Room' started by HeliGods, Apr 25, 2014.

    1. Geena

      Geena Well-Known Member

      My TSA kits come with little wire clamps that snap into the frames. They work really well, and will hold several wires without doing damage to them. Around the FBL controller and other electronics, I do the same as you mentioned with velcro, and small zip ties.
       
      Geena, Apr 25, 2014
      #2
    2. 3D Heligod

      3D Heligod Moderator Staff Member

      Do these wire clips keep the wires off the frames @Geena ? I imagine they would be ok because they are provided in the kit. One thing that I found out the hard way was how conductive the carbon frames are. It only takes a positive wire to touch the frame and the carbon will start to smoke, char and even potentially burn.
       
      3D Heligod, Apr 25, 2014
      #3
    3. Andrew R

      Andrew R Active Member

      +1 for velcro and zip-tie
       
      Andrew R, Apr 25, 2014
      #4
    4. Geena

      Geena Well-Known Member

      They don`t prevent them from touching the frames, but I dab a small amount of liquid electrical tape on the wires where the clamps are. No problems so far. :)
       
      Geena, Apr 25, 2014
      #5
    5. hgnimda

      hgnimda Ray - Administrator Staff Member

      Thats an excellent idea! Liquid electrical tape. I have never heard of it before. Sound like good stuff.
       
      hgnimda, Apr 26, 2014
      #6
    6. Geena

      Geena Well-Known Member

      I get it from the hardware store next to our work shop. It`s good stuff.


      0002269730111_500X500.jpg
       
      Geena, Apr 26, 2014
      #7
    7. MadBird

      MadBird Well-Known Member

      I haven't used it before, but I have heard if people using a bead if it along the edge of their CF frames to prevent chafing of the wires. Jaycar has a similar product here in Oz.


      Sent from my Electronic Appendage!!
       
      MadBird, Apr 27, 2014
      #8
    8. Radar

      Radar Moderator Staff Member

      Yep I use zip-ties and Velcro to protect the wires. But liquid elec tape would be a great idea, I have been using it for a while but not to hold down wires on my Heli. Great idea @Geena
       
      Radar, Apr 28, 2014
      #9
    9. hgnimda

      hgnimda Ray - Administrator Staff Member

      Does anyone know of the same sort of stuff that @Geena is talking about in AUS? I think it would be handy to fix nicked wires etc..
       
      hgnimda, Apr 28, 2014
      #10

Share This Page