Tail Gyro Hunting In Nose Dive Post Stall Turn

Discussion in 'Futaba CGY750 FBL System' started by Stuart, Aug 14, 2014.

By Stuart on Aug 14, 2014 at 8:09 PM
  1. Stuart

    Stuart Active Member

    Attempting to tune out a tail issue. Have a CGY750 on my TREX 500. I now have it flying really smooth and to my liking except one issue.

    In a nose dive post a series of fast piros as part of a stall turn the tail does a number of left right kicks stopping as I flatten out.

    It does not do it if I just do a slow single piro, only after full rudder multi piros.

    I have turned the gyro back a couple of clicks, it still did it. I suppose I could keep turning the gyro down but I'm thinking there may be another parameter I could adjust.

    Any ideas?
     
    Stuart, Aug 14, 2014
    #1

Comments

Discussion in 'Futaba CGY750 FBL System' started by Stuart, Aug 14, 2014.

    1. mr_squiggle

      mr_squiggle Well-Known Member

      Do the left right kicks get smaller each time before stopping?


      Citizen #186
       
      mr_squiggle, Aug 14, 2014
      #2
    2. Stuart

      Stuart Active Member

      yes i think they do
       
      Stuart, Aug 14, 2014
      #3
    3. Stuart

      Stuart Active Member

      Solved, thanks to the guys at AFF today. Adjusted the tail gain to no effect. Then upped the CNT.Dout from 10 to 14.

      This parameter sets the delay when the stick is returned back to the neutral position. This pa-rameter is useful to tune how aggressively the tail rotor stops following a pirouette. The higher the value, the softer the stop.
       
      Stuart, Aug 15, 2014
      #4
    4. 3dmick

      3dmick Well-Known Member

      well done stuart the 500 looked like it was in a happy place at the end of the day
      what a awesome day at AFF it was like summer is back for the day and no wind
       
      3dmick, Aug 15, 2014
      #5
    5. Stuart

      Stuart Active Member

      Yeah it was a great couple of hours in the sun.., wished I'd got there earlier...
       
      Stuart, Aug 15, 2014
      #6

Share This Page