New Sab Goblin 380 Swash Leveling Tool / Partial Fail!

Discussion in 'SAB' started by The Dude, May 19, 2015.

By The Dude on May 19, 2015 at 2:42 PM
  1. The Dude

    The Dude Well-Known Member

    Great for a quick setup but not much good for doing high and low leveling on the swash !

     
    The Dude, May 19, 2015
    #1

Comments

Discussion in 'SAB' started by The Dude, May 19, 2015.

    1. Kyle Orrock

      Kyle Orrock New Member

      To be honest with the 380 there is no need to do a high and low level if u are using arm of the correct length and a good FBL unit it will compensate for the tiny amount it could be out


      Sent from my iPhone using Tapatalk
       
      Kyle Orrock, May 20, 2015
      #2
    2. The Dude

      The Dude Well-Known Member

      True, if a good FBL unit it will compensate for it, then we don't need to be very fussy with leveling the swash at all.. However i personally like my setups to be spot on for top and bottom, it makes a difference, especially on the smaller heli's ...
       
      Last edited: May 20, 2015
      The Dude, May 20, 2015
      #3
    3. 3dmick

      3dmick Well-Known Member

      I just used a bearing that fits on the main shaft works fine
       
      3dmick, May 20, 2015
      #4
      • Like Like x 1
      • Informative Informative x 1
      • List

Share This Page