Hi Todd, Thanks for dropping in.... Maybe you can post some basic setup info for us.. in here

 

I am posting from my phone right now, but I can get the latest setup docs uploaded when I get to my laptop, and go over some basic setup tips as well

 

That would be great, would be some good info, No hurry ... Thanks again ..

 

That would be kewl, I'm looking at getting one...

 

Sweet im giving a vx1n a crack on my hd cell so far so good.
Im sure your knowledge will be appreciated here

 

Let me know if you have any questions, and I'll make sure we get it answered. The nano is a great piece of kit!

 

Sweet man will do once I get my new xnova ill be able to push it a bit harder then ill have some tune questions.

Cheers

 

All good!

One of the most common questions falls around elevator debounce. If you are getting excessive bounce, bring both the cyclic gain and elevator debounce down, that should clear it up!

 

Sick cheers Todd

 

Any set up videos Todd

 

Theres a few BOB O off helifreak did he goes through the whole setup
HAVE A SEARCH ON YOUTUBE

 

Watch "Bert Kammerer talks about the Spartan Vortex" on YouTube
Bert Kammerer talks about the Spartan Vortex:

Bert being bert

 

I thought it was pretty cool actually, probably only the aileron loop but some nice moves there. I noticed during the piroflip it was locked in very solid.

 

@ ToddMoriarty
Hi man what ports can I use for power supply on the vx1n?

I want to run 2 power ins but the only one im sure I can use is the data pod port.
Can I use the rx port to supply power?

Thanks

 

Yes, you can! I run Futaba, and I actually run 1 lead to the RX and 1 lead to the datapod port. This way I have power when I have the datapod attached for remote tuning. On the nano, you can use anything but the RPM sensor and aux3 port (the 2 bottom ports), as these are on a separate, regulated power bus.


Sent from my iPhone using Tapatalk

 

Bloody rippa thanks mate.

The gobby 630 is on v3 this should be real good.

I chickened out on the bertK preset and went with 3d

 

3d is a good start to tune your gains, etc. I haven't gone through parameter by parameter, but BertK primarily increases the flip/roll rates, sets tail rotation and acceleration rates, and adjusts style/ paddle response. It will heat up the responsiveness quite a bit, but won't make the Heli unflyable. I would assign a flight mode to it, and try it out if you are curious about it


Sent from my iPhone using Tapatalk