I have a vbar here if you like mick.. haha
the original DFC by SAB was prone to boom strikes, which is why they made up the HPS 2 head...
Servo install. Now I should have done the aileron cyclics earlier, as it would have been easier, but I didn't. so what I did was undo the entire...
Next is the main gear... pull it all apart... with the bronze bushings.. I got some 1200grit sandpaper from bunnings, put some oil on the...
Put the other from on... then put the main shaft in, hold it on a flat surface, and make sure the frame is square.. and tighten the bolts... Once...
Now the bearing blocks.. as mentioned these are thrusted, with radial bearings, so very much like the setup in your blade grips.... pay attention...
Now back to as per the manual... Make sure you sand the frames. The frames felt pretty smooth already, but it never hurts to go over them... Put...
Ok.. as always start by opening the box and laying out the parts.. everything is "factory assembled" but this is purely for parts count.. pull it...
[IMG] Hello, Well I was lucky enough to get one of these kits from the first batch in Aus from ARKRC... At the moment I believe they are...
Looking good Dan... mine is still in progress.. [IMG]
would be interesting to see.. most models have gone away from DFC due to the forces on a single bolt... but with a smaller model should be...
Yep that's the one hardsy... That will get you to 626...
What tail ratio are you running? If stock I would run the 105 if the speed up tail 95
And he flew in 4s.. So can fly it in the old 450 zone
[IMG] Ok so to continue my way down the dark side of quads.. I picked up on of these... the other day .. thanks for the hookup @BladeBandit ......
I think I have swapped out one belt since I went 6s xnova, with the solid pinion.. but I dont smack it no where near as hard as @smakmeharder ......
lol remember when Helicraze we flying his at MRCHC... everyone just stopped and watched.
Yeah head holding mode will make the tail try and keep the nose pointing in the same direction... Rate mode only cares about the input.. Won't...
Maybe list out the dimensions.. Might be able to get Josh to 3d print something that would fit
I still spend 5 min at least everytime I sim just for piroflips
Separate names with a comma.
